Full automatic refrigerant cleaning system for automobile A/C Freon Cleaner C60
[Applicable refrigerant] R134a
One machine does all 5 jobs; refrigerant recovery·charging·recycle·vacuum pulling and oil charge.
|| Purpose
Recovery and recycling of refrigerant from auto A/C.
Charging refrigerant and oil to auto A/C.
Improves cooling power of the auto A/C by cleaning the refrigerant.
|| Features
•
Fully automatic recovery, recycling, vacuum pulling and charging.
•
Large and easy to read LED display with key pad to set the charging amount.
•
Equipped with 2 special filters which eliminate particles from contaminated refrigerant and increase cooling ability.
•
Equipped with 2 vacuum pumps to dry the A/C system and eliminate moisture, acid, etc.
•
Separates refrigerant and oil by heat exchange system.
•
6L cylinder is set in the unit.
Self certified according to the MITI Notice No. 139.
Additional charge of refrigerant
Error display
Refrigerant recovery only
Check the input value and
the amount of recovered refrigerant.
Residual refrigerant in the system and
hose can be removed to protect environment.
|| Specification
Item
Freon Cleaner C60
Freon Cleaner C60
(without vacuum pump)
Code No.
FC060
FC060S
Applicable refrigerant
for R134a only
Function
Cleaning mode
Recovery/ recycling·evacuating·charging
Recovery/ recycle·charging
Additional charging mode
Charging
Recovery rate
240g/min.(*120g/min)
Compressor
375W(1/2HP)Oil-less type
Vacuum pump
Displacement
22.5·27L/min. (50/60Hz)
—
Ultimate vacuum
1.333HPa(10 micron)
—
Equipped cylinder
6L cylinder (stationary)
Oil separator
Heat exchange system 900mL
Attachment of service can
1 location
Attachment of oil can
1 location
Filter dryer
2 pieces–replaceable
Pressure gauge
High side
-0.1∼3.5MPa
Low side
-0.1∼2.0MPa
For cylinder
-0.1∼3.5MPa
Setting
Display
Red LED(H14mm)
Input
Ten key
Charging amount
100∼2000g(every 10g)
Evacuating time
3∼60 minutes
Oil amount
0,1,2 can(by number of can)
Weighing method
By load cell
Safety device
Pressure switch·Spring safety valve·Breaker
Operating temperature
5∼40ºC
Power source
AC100V 50/60Hz
Dimensions(L×W×H)
640×610×1290mm
Weight
78kg
70kg
Standard accessories
1/4"High pressure and low pressure charging hose for R134a (2.5m),
1 pce. each, Thermometer, Filter dryer×2 pcs.,
1 pce. each High and low pressure quick joint
*Rates are result of actual test by ASADA.
*Rates varies under different conditions.
*Gas recovery rates are based on the inspection standards of RRC and tested with the hose included in the standard accessory.
Printer specification
Item
Freon Cleaner C60 with printer
Freon Cleaner C60S with printer
Code No.
FC060P
FC060SP
*Only the Freon Cleaner C60 (Code No.FC060·FC060P) with vacuum pump can pull vacuum.
Printer specification
To the top of page
Copy Right and its Link
